We all know that no matter what equipment it is, it must be adjusted and adjusted before it can work normally. What is the posture of the pipe cutting machine? Now give us a brief introduction to the device description of the pipe cutting machine:
1. After using the pusher to push the device to the location, put it down quietly, and do not fall or make strong bumps.
2. Use a spirit level to adjust the machine to a horizontal position.
3. Be sure to connect the green bottom line to avoid the risk of leakage.
4. Connect the power cord, please connect the non-fuse switch or the knife switch, pay attention to the lack of phase, to avoid the motor cannot be started and burned. After starting the motor, check whether the working direction is the same as the red arrow on the saw blade guard. If the rotating shaft is opposite, swap the two power cords in between. Note that the green ground wire cannot communicate.
5. Be careful not to change speed when sawing. If you need to change speed, first turn off the spindle and wait for the spindle to stop completely before changing the speed to avoid damage caused by malfunction of the motor or spindle head gear.
6. When installing the saw blade, refer to the red arrow device on the saw blade protective cover, and the saw blade cannot be reversed to avoid the risk of saw blade breakage. Tighten the saw blade and lock the bolts in the opposite direction of the red arrow. It is determined that the saw blade has been locked and will not loosen before the spindle can be started. The loose saw blade will be maintained and protected during sawing.
