First of all, it is necessary to confirm the brand of the hot melt glue machine to be connected, which country is from, the length of the hot melt hose, and the inner diameter of the hot melt hose, these basic data.
Secondly, take photos of the plugs at both ends of the hot melt hose to be replaced to the hot melt glue machine parts manufacturer to confirm whether it is the conventional hot melt hose connection method and the pin connection position, so as to avoid incorrect positions and receive After delivery, it cannot be plugged in and cannot be used.
Then it is necessary to determine whether the hot melt hose is used for strip-shaped or spiral spraying. If it is a strip-shaped hot-melt hose, there is no need to add a Teflon air hose, while the spiral hot-melt hose is Be sure to add an extra tube. Here, the editor will give everyone a little knowledge. The spiral rubber ring is blown out by the air pressure in the trachea. So we must pay attention before this.
As one of the main parts of the whole hot melt glue gluing machine system, the hot melt hose is indispensable, and it can transport and keep the liquid hot melt glue. The hot melt hose is resistant to bending, has a low failure rate and stable performance.
